How to tattoo yourself

How to tattoo yourself safely and briefly? You must be curious about it, do not worry, this article will teach you how to do it. Because of the different habits from different artists, this article only show you the common method and a general introduction, in which we hope can benefit to you. There are many steps you can follow:
Firstly, think about if you really want a tattoo. A tattoo is permanent in  your body, and it may have an affect on your job. If you really want to have a tattoo, make sure the design is fit you, and you won’t regret after tattooing.
Secondly, select the design you loved, choose a impression basing on the design. Put the it on the transfer paper. Use the pencil or pen line around the design, then a perfect outline on the other side of white paper will be shown.
Thirdly, prepare the tattoo supplies in the desk and the clean the tattoo place. Wearing the latex gloves. Make sure all tattoo supplies are clean and sterilized and you have set up your tattoo machine well, both the liner machine and the shader machine. If there is only one machine, set up the matched needles. You need to line first. Put the ink cup in the ink holders, then put the ink into the ink cup, so that you can use the ink conveniently. Spray the shrink water in your body area, then wipe it clean. Spray the disinfection reagent later, wipe it. The same way operating with the shrink water. Then shave the hair with the razor to make your body more clean. Spray the disinfection reagent and wipe it at the end.
Fourth, pour the impression on the body. At this time, think again, are you really want to have tattoo, do you like the picture? if your answer is yes, just do it.
Fifth, outline the tattoo design with the liner machine. Before doing it,  spray the disinfection reagent, and wipe it. Smear cream later to make your skin moist and smooth. Handle the liner machine, connect it with tattoo power supply, and plug the foot pedal into the other side of the machine. Outline the design in correct way.
Sixth, Spray the disinfection reagent and wash the impression again. Smear cream. Shade the design with the shader machine. When you change the color, remember wipe the needle clean. After doing it, clean the design with disinfection reagent. Then smear the ointment. Cover the tattoo with gauze, and tie it with the medical paper tape. Keep it covered for several hours to make the ink penetrate into the body.
This is the whole tattooing. If you tattoo yourself, make sure you are in a clean environment and you are using the superior tattoo supplies. Take care of your tattoo after doing it, do not swim, do not exposure under the blazing sun for quite a long time. Use the tattoo aftercare when needed. Hope this article can help sincerely.