Seven key steps to debug the tattoo machine

The first step the tattoo machine needles with his left hand  with index finger to resist "host" bottom Department  the thumbs down "Needle fixed button" location. The second step connect ac power jack cable access tattoo machine. The third step in the right hand thumb and forefinger "adjust the fixed button" to "relax" state. The fourth step in the right hand thumb and forefinger "pressure regulating knob"  to adjust the pressure regulating knob at the same time Right foot pedal switch " start tattoo machine. Step 5 the right hand thumb and forefinger "Pressure regulating knob" pay attention to the right hand has been to leave or put loose "Pressure regulating knob" until tattoo machine to produce the best speed and sound. At the same time with the left hand thumb belly touch the magnetic force The front end of the article  needle bar fixed button below. In the left hand thumb tactility is maximum vibration  to feel numb Wood, itch so far   tattoo machine is the best working state at this time. Step 6 in the debug tattoo machine  tattoo machine should pay attention to our trip   trip for tattoo machine The magnetic force and magnetic coil  this trip must ensure that at least for the spacing The 2.5 MM . Because this is confirmed Have enough telescopic distance to ensure that the needle can Pierce the skin when stretched out the underlying  while retracting can retreat into again Stick to a pigment in the needle. Step 7 To the best state   tattoo machine left right foot "foot switch" lines - breaking power Machine body is in a state of downtime  in the right hand thumb Fixed button "adjustment" means and the index finger to adjust to the tight state  the lock Set" Press button" .